SIO Argo Site: Delayed Mode
Quality Control Tabulation Page

Serial= 8510 WMO= 5902501


←Previous Next→

Currently Assigned Quality Control Flags
Display of the floats Delayed Mode Quality Control flags as recently reported at the GDAC.
Plot may lag the GDAC by up to 10 days.
Colored circles represent the 1 (blue) to 4 (red) Argo QC scale. The dots are overlain on a contour plot of the profile data

Temperature Salinity Plot of Quality Controlled Data
Temperature/Salinity diagram of Quality Controlled Argo profile data.
The data is color coded by QC status (Delayed Mode or Real-Time) and goodness [Argo flag 1 (good) or other (bad)].

Currently Assigned Sensor Drift Corrections
These are the drift corrections found in the Delayed Mode netcdf profile files at the GDAC. Error bars are also shown.
If no lines are shown, then the data has not yet passed through DMQC.

If present, the below figures are produced by the OW (Owens and Wong, 2009) salinity calibration software.
This software is used throughout the Argo program to access the presence of salinity drift.

OW Argo Delayed-Mode Salinity Calibration Plots
OW Diagnostic Plots for Salinity Drift Identification: Float 5902501
Figure 1: Uncalibrated float measurements with historical estimates. (Click for larger image) Figure 2: Calibrated float measurements with historical estimates. (Click for larger image)
Figure 3: OW time series of correction, in potential conductivity (top) and salinity (bottom). (Click for larger image) Figure 4: OW time series of salinities on potential temperature levels. (Click for larger image)
Figure 5: Chosen levels in OW (Click for larger image) Figure 6: Float spatial migration and historical data locations. (Click for larger image)